Motoklik system example overlaid on motorcycle.
- Central Control Unit (CCU) located between the triple clamps and behind the front number plate.
- Satellite Position Antenna located on the handlebar.
- Front Suspension Measurement Wand located on the left fork leg.
- Rear Suspension Measurement Pack located between the frame and brake master cylinder.
- Motoklik Central Control unit. This unit is used to distribute power to each of the sensors, record the data from those sensors, and transmit the data via Bluetooth to the mobile app. The unit also contains a 1000mAh 3.7v Lithium battery.
- Satellite Position Antenna. The antenna is used to identify and fix to satellites to calculate the current antenna position in latitude, longitude and altitude, and calculate the speed the antenna is moving. The unit also has a clear button cap that can be illuminated in green and red. Flashing red indicates the antenna is trying to obtain a satellite fix, flashing green indicates the satellite is fixed, and solid green indicates that the Motoklik is recording data.
- Front Suspension Wand. The wand houses an array of sensors that the determine the front suspensions position based off of the relative position of a magnet located in no. 5, the front magnet housing.
- Rear Suspension Sensor. The rear sensor houses an array of sensors that the determine the rear suspensions position based off of the relative position of a magnet located in no. 6, the rear magnet housing.
- Front Magnet Holder. The holder encloses a 15mm x 5mm Neodymium disc magnet, and connects to the front fork guard of the motorcycle. This part replaces the front brake line clamp holder.
- Rear Magnet Holder. The holder encloses a 15mm x 5mm Neodymium disc magnet, and connects to the swingarm on the rear of the motorcycle. It is held in position by bolts used for holding the rear brake line guide in position and / or a cable tie(s).
- Power Supply Cable. The cable assembly is made up of three components, the Motoklik connector, the OBD connector (8), and the fuse (9).
- OBD Connector. This connector plugs directly into the motorcycles wiring harness and is used to draw a 12v power supply from the motorcycle which is used to power the Motoklik. The power supply from the motorcycle is on a relay which turns off after a certain period when the engine is not running e.g. 30 seconds. When the power supply is removed, the Motoklik device is powered by the internal battery for 10 minutes, and then it turns off also.
- Fuse. The powers supply cable also includes a 1A blade type fuse to keep power consumption below 15w.